Personal tools
You are here: Home Forum Use Open issues that aren't on the the roadmap

Open issues that aren't on the the roadmap

Up to Use

Open issues that aren't on the the roadmap

Posted by Kunda at December 07. 2017

Issues

https://tracker.dev.opencascade.org/view.php?id=25521 (Fillet creates shell with bad orientation of SubShape)

https://tracker.dev.opencascade.org/view.php?id=25626 (Loft of ellipses shows wrinkle near seam edge)

https://tracker.dev.opencascade.org/view.php?id=25781 (BOP of coincident torus and cylinder fails in BeanFaceIntersector)

https://tracker.dev.opencascade.org/view.php?id=25776 (HLR returns intersecting edges in OutLineV of helical sweep)

https://tracker.dev.opencascade.org/view.php?id=25879 (result of blend fails the bopcheck)

https://tracker.dev.opencascade.org/view.php?id=25979 (fillet creates faces with non-closed wires)

https://tracker.dev.opencascade.org/view.php?id=26295 (Sweep fails with BRepFill_ContactOnBorder)

are not on the roadmap. Could it be possible to put them on? They are downstream FreeCAD issues. 

Thanks you in advance!

Re: Open issues that aren't on the the roadmap

Posted by Kunda at December 08. 2017

Anyone care to take a look at these and possibly add them to the roadmap ?

Re: Open issues that aren't on the the roadmap

Posted by SMESH expert at December 08. 2017

Hello Kunda,

OCCT has it's own forum, address there https://dev.opencascade.org/index.php?q=home/forum

Persons who can do that do not watch this forum.

Best regards

Edward

Re: Open issues that aren't on the the roadmap

Posted by Kunda at December 09. 2017

Previously SMESH expert wrote:

Hello Kunda,

OCCT has it's own forum, address there https://dev.opencascade.org/index.php?q=home/forum

Persons who can do that do not watch this forum.

Best regards

Edward

Thanks for the heads up, Edward. I'll post there. Much appreciated.

 

Powered by Ploneboard
Document Actions