Personal tools
You are here: Home Forum Use 2 groups of faces and 2 groups of volumes in mesh and code aster finds only the ones of the faces

2 groups of faces and 2 groups of volumes in mesh and code aster finds only the ones of the faces

Up to Use

2 groups of faces and 2 groups of volumes in mesh and code aster finds only the ones of the faces

Posted by Panagiotis Sterpis at September 19. 2017

Greetings,

 

 

First of all i'm newbie to cae linux-salome-code aster. I have a brick wall that i imported from a STEP file. I meshed it and i've created 2 groups of faces on for the base and on for the top(pression) respectively and 2 groups of volumes for the bricks and the mortars respectively. I define the materials in eficas etc, i run code aster and nothing. I've encountered an error {le GROUP_MA <>  ne fait partie du maillage: .....} while inspecting the generated .mess file ,plus to the list of groups of the mesh only the first set of two is noted.

Any ideas in how i can enable the created groups on code aster?

 

 

Thank you in advance.

 

PS: Any file is available for upload when needed.

 

Powered by Ploneboard
Document Actions