Personal tools
You are here: Home → Forum → Use → Using hexaehedral elements and Exporting a file
 

Using hexaehedral elements and Exporting a file

Up to Use

  • Using hexaehedral elements and Exporting a file

    Posted by Isabel at December 13. 2005
    Hello everybody!!

    I have just known this program and I am very interesting in it.
    I would like to start to use Salome in order to get the following aims:
    - I have to mesh a 3D geometry with unstructured hexahedral elements.
    - I have to export both the geometry and the mesh into a ucd file.
    Is it possible to do all this with this program?

    I will be very grateful for your replies.
    (This question is also in the Community section because I am not sure where to post it)
    Best regards!
    Isabel
Powered by Ploneboard
Document Actions