Personal tools
You are here: Home → Forum → Use → Export mesh to UNV format (IDEAS)
 

Export mesh to UNV format (IDEAS)

Up to Use

  • Export mesh to UNV format (IDEAS)

    Posted by Benjamin at April 13. 2006

    Hello,

    I follow with a previous post published a couple of month ago about the possibility to interface Salome and OpenFoam (CFD solver).

    Is it possible with salome 2.2.8 to export a mesh and its group to an UNV format? in the previous version only the whole mesh was exported but without the groups, ie the inlet and outlet faces, walls, ...

    Is there an utility to convert a med file to other formats?

    Thx for your answer.

    Benjamin

    • Re: Export mesh to UNV format (IDEAS)

      Posted by Sergey Mozokhin at April 14. 2006
      Benjamin wrote:

      Hello,

      I follow with a previous post published a couple of month ago about the possibility to interface Salome and OpenFoam (CFD solver).

      Is it possible with salome 2.2.8 to export a mesh and its group to an UNV format? in the previous version only the whole mesh was exported but without the groups, ie the inlet and outlet faces, walls, ...

      Is there an utility to convert a med file to other formats?

      Thx for your answer.

      Benjamin


      Hello,

      Possibility to export/import groups to UNV will be in SALOME version 3.2 only.

      Best regards,

      Sergey.

       

Powered by Ploneboard
Document Actions