Hydrofoil geometry.

Hello,

I am beginner.

I want to create an hydrofoil profile (2D) starting from 200 points approximately.

To create my geometry, I joined these points Then I used arc between each 3 points and I obtained finally the profile attached. I didn't find another means.

How can one collect these arc to have a unit solid volume (Hydrofoil) ?

Regards.

Rezki.

Hello

Instead of using arcs, you might create a spline (new entity/curve) from your points set.

Then make a wire from this curve, and a face from this wire

Extruding this face will give you a solid

Best wishes

JMichel