Personal tools
You are here: Home Forum How to use Salome? What are the dimensions?

What are the dimensions?

Up to How to use Salome?
  • What are the dimensions?

    Posted by Samuel Pang at April 21. 2008

    Hi, I am not sure what dimensions Salome uses. While drawing out my solid in the geometry module, I set a length that was 1, thinking that it's 1m. However when I exported the mesh to OpenFOAM to solve, I realized that even with a flow of 1m/s (which means that the fluid will reach the end of the mesh in 1sec), my fluid seems to cover the entire mesh in about 0.2 seconds. Is there some way I can find out what the dimensions are when I draw my geometry?

    Thanks!

    • Re: What are the dimensions?

      Posted by Sam Patterson at June 17. 2008
      I'm also wondering this too, I've been assuming the measurements were in millemeters by default, but am not 100%. any help would be much appreciated!
Powered by Ploneboard
Document Actions