Personal tools
You are here: Home Forum Install & build NETGEN Plugin


Up to Install & build
  • NETGEN Plugin

    Posted by Todd Martin at September 19. 2008
    I compiled Salome 3.2.6 on Mandrake 10.1 with the Netgen 4.5 source code, which I downloaded independently.

    When I run Salome and chose the Netgen 2D-3D hypothesis, in the mesh module, I get the following error
    undefined symbol _ZTIN6netgen13ExtrusionFaceE
    in SMESH_I/SMESH_Gen_i.cxx : 355

    Has anyone seen this before?

Powered by Ploneboard
Document Actions