Skip to content. | Skip to navigation

Sections

Personal tools

You are here: Home → Forum → Install & build → NETGEN Plugin

Recent messages: Re: Detection of non-orthogonal and skew faces for OpenFOAM meshes Extension of the platform; Visualizing the interiors of the geometry How to use Salome?; How to install Salome / Salome installation on Linux Install & build; can not start salome in opensuse leap 42.3 Install & build; Re: Mesh 2d airfoil with viscous layer Use; More…

NETGEN Plugin

Up to Install & build

NETGEN Plugin
Posted by Todd Martin at September 19. 2008

Hi
I compiled Salome 3.2.6 on Mandrake 10.1 with the NETGEN_PLUGIN and Netgen 4.5 source code, which I downloaded independently.

When I run Salome and chose the Netgen 2D-3D hypothesis, in the mesh module, I get the following error
libNETGEN.so.0
undefined symbol _ZTIN6netgen13ExtrusionFaceE
in SMESH_I/SMESH_Gen_i.cxx : 355

Has anyone seen this before?

Todd.

Powered by Ploneboard

Document Actions