Personal tools
You are here: Home → Forum → Install & build → meshing
 

meshing

Up to Install & build

  • meshing

    Posted by mohsen hajihashemi at May 22. 2006
    Hello everybody
    I tried to use SALOME to solve a stratified_flow_pipe problem in 2D.I dont know how to mesh teh figure because I need to mesh along the radius.I want to divide the 2 arcs into 16 segments and two line edge into 8 segments.Based on this division the face should be meshed with quadrangles.this is figure .

    • Re: meshing

      Posted by mohsen hajihashemi at May 22. 2006



      • Re: meshing

        Posted by Manfred Staat at May 22. 2006
        mohsen hajihashemi wrote:

        The figure is the symmetric half of the cross-section of the pipe: ◎ i.e. if this can be visualized here

        >
        > <td
Powered by Ploneboard
Document Actions