Personal tools
You are here: Home Forum Use Selection of edges very slow in Shaper

Selection of edges very slow in Shaper

Up to Use

Selection of edges very slow in Shaper

Posted by Konyaro at May 03. 2020

Hello,

When creating groups in Shaper, the selection of many edges takes lots of time. For example in the attached example, if I try to create a group of all edges by drawing a rectangle around the part it takes about 1 minute to get the edges. It takes less than 1 second in GEOM. If the number of edges gets higher it takes more than one hour.

Attached an example with a STEP file and the dumped script to get the 2D geometry (the path must be changed in the script).

Regards,

Konyaro

Attachments

Re: Selection of edges very slow in Shaper

Posted by Christophe Bourcier at May 04. 2020

Hello,

I confirm it is very slow on your shape with only 212 edges.

If you just want to create a group with all the edges, you can select Face_1_1 in the group creation panel instead of selecting the edges in the view.

Christophe

Re: Selection of edges very slow in Shaper

Posted by Konyaro at May 04. 2020

Hello,

Thank you for your answer. The trick of selecting the whole face works well in that case. Unfortunately, I often have this issue and sometimes I need to select only a special region of edges. In that case, I create the group in GEOM so it’s not a big issue as GEOM is still there :)

Best regards,

Konyaro

 
Powered by Ploneboard
Document Actions