Personal tools
You are here: Home Forum Use Apply a custom transformation to a part of an assembly?

Apply a custom transformation to a part of an assembly?

Up to Use

Apply a custom transformation to a part of an assembly?

Posted by Christophe Trophime at July 03. 2019

Hi,
I would like to apply a custom geometric transformation to a part of an assembly
and keep the groups definition on the "transformed" part and over the whole assembly.

My transformation consists in a rotation with an angle of rotation that depends on Z coordinates.
The angle will be defined by series with Bernstein polynomials.

I wish to create a new assembly with the transformed geometry and the same groups as in the original.

Is this kind of transformation may be defined easily?
What is the scenario I shall use (especially to keep the groups definition)?

Best

C.

Powered by Ploneboard
Document Actions